Certified quality management system
Measurement Technology
Measurement engineering is a major division of Sourcetronic. Your measurement engineering specialist, specialized on highly diverse measurements, such as resistor measurements, LCR, high voltage, isolation resistors, security tests but as well multimeters, oscilloscopes and software.
- Factory calibration by express
- Turnaround time of 24 hours after arrival
- Valid for orders of up to 3 unit
- Appointment coordination in advance
- Accuracy: 0.05%
- Frequency range: 50 Hz - 100 kHz
- Measuring speed: 13ms
- DCR: 0.00001 Ω - 99.9999 MΩ
- Resolution: 6 digits
- Display: Colour TFT 4.3"
- Interfaces: USB, RS232, handler, optional: GPIB
- Extra: ST®Meter 4.0 software, incl. accessories
 (1)_400x400.jpg?ts=1657702146 "Winding Goods Test System STW")
- Fully automatic Relay matrix STM-8-4
- User-friendly ST®EOL software
- Modular 19″ industrial cabinet
- Industrial PC with WIN 10 or higher
- Touch monitor, scanner and label printer
- Safety standard IEC/EN60947-5-1
- CE compliant according to EN 50191
- 10.000 V Megohmmeter
- Insulation resistance 10 kΩ - 10 TΩ
- Digital & bar-graph reading
- Auto-tests: Absorption Ratio, Polarization
index, Capacitance, Leakage current,
AC/DC voltmeter - Switchable filter to remove external-noise
- Step voltage test
- Built-in printer (option)
- 4000 readings memory
- Isolated USB data port
- Bluetooth interface
- Software for data management
- Rechargeable battery
- 100 A Low-Resistance-Meter
- Direct reading up to 4 ½ digits
- Resolution: 0.1 µOhm
- Heavy duty equipment
- Overheating protection
- Internal memory for 200 readings
- USB Port
- Protection IP54
- Installed version, interface RS232
- The built-in protocol printer is installed in the front of the offered test instrument. The printer can be activated or deactivated via pushbuttons. A printout is made immediately after the end of the test. The connection to the testing device is made at the back of the device via a cable connection. Thus further test devices can be connected to the same protocol printer. A changeover switch is therefore not required if the tests are carried out consecutively
- 20KV Megohmmeter
- Insulation resistance up to 4TΩ
- Test voltages: 5kV - 20kV
- Guard terminal
- Rechargeable power-battery
- Multiple scales for precision improvement
- Charger 110 and 230 V
- Accurate & rugged Heavy-Duty-Equipment
- IP-54 protection
- CE mark
- Diagonal rail clamp tap to connect a test lead on the rail
- with threaded bolt
- 2x Contact protection DK 21
- Compatible with high-voltage relays (RL 21), RL 42, RL 42-LC
- Contact protection made of insulating plastic
- Simple plugging and unplugging
- Built-in voltage source: ±1000 V, resolution: 700 μV
- 5.0-inch capacitive touch screen
- Measurement Range up to 10 PΩ
- 6½-digit measurement resolution
- Interfaces: Handler, GPIB, LAN, RS232C and USB