Certified quality management system
Accessories for Ground Bond Tester
- Alligator clip set: ST26035B
- Devices: ST9410A, ST9411A
- Current: 45 A
- Cross-section: 6 / 4 mm²
- Length: 1.50 m
- Protective earth cable red with: Plug SENSE+/Current, insulated alligator clip red
- Protective earth cable black with: Plug SENSE-/Current, insulated alligator clip black
- Diagonal rail clamp tap to connect a test lead on the rail
- with threaded bolt
- Installed version, interface RS232
- The built-in protocol printer is installed in the front of the offered test instrument. The printer can be activated or deactivated via pushbuttons. A printout is made immediately after the end of the test. The connection to the testing device is made at the back of the device via a cable connection. Thus further test devices can be connected to the same protocol printer. A changeover switch is therefore not required if the tests are carried out consecutively
- RS232 cable for protocol printer module PDM36
- external connection CONTROL - printer interface
- 9-pin. SUB-D female
- cable 30 cm length
- 9-pin SUB-D male
- PIN 3&5 1:1
- With magnetic switch
- With screw joint for connection of a cable socket
- For magnetic contacting
- Devices: 36 & 400
- 4-pole (Sense/Source)
- PE plug: PES4
- Battery clamp
- Operation current: 32 A AC
- Devices: 36 & 400
- 4-pole (Sense/Source)
- PE plug: PES4
- Battery clamp
- Operation current: 32 A AC
- Devices: 36 & 400
- 4-pole (Sense/Source)
- PE plug: PES4
- Magnet contact
- Operation current: 32 A AC
- Test probe with 4-wire measurement technology
- 7-pin, PE plug PES7
- Button for start / stop of the measurement
- Test current is only enabled after contact has been made
- Result display via 2 multi-colour LEDs (red / green)
- Quick tip change possible (screw-off tip)
- Selectable cable length: 2 m, 3 m, 5 m or 10 m (other cable lengths on request)