Certified quality management system
Measurement Technology
Measurement engineering is a major division of Sourcetronic. Your measurement engineering specialist, specialized on highly diverse measurements, such as resistor measurements, LCR, high voltage, isolation resistors, security tests but as well multimeters, oscilloscopes and software.
- RS232 cable for protocol printer module PDM36
- external connection CONTROL - printer interface
- 9-pin. SUB-D female
- cable 30 cm length
- 9-pin SUB-D male
- PIN 3&5 1:1
- Contact unit for connecting an HVP06N test pistol to the ST9201
- 1x Schuko socket
- 1x push-button switch for closing the safety circuit
- 1x pushbutton switch to start the high-voltage test
- Voltage: 5 KVAC, 6 KVDC
- Ergonomic design
- Highly insulating special plastic
- Choice of devices:
- Gossen: MetraClip 86
- Fluke: 322, 323, 325, 353, 374 FC, 375 FC, 376 FC, A3001 FC
- Benning: CM2, CM7, CM8, CM9
- Beha Amprobe: AC50A, AD40B
- Chauvin Arnoux: C.A. 6412, F65
- and many more
- Ergonomic HV test probe
- High voltage testers: SPS electronic, Schleich,
Elabo, ETL, HCK, Erfi and many more - Nominal current: 35A AC
- Flexible safety connection cable
- Resistance-resistant tungsten tip
- Highly insulating plastic
- Button for starting/stopping the measurement
- Result display via LED (red/green)
- For the RS36 protective conductor tester
- Factory calibration by express
- Turnaround time of 24 hours after arrival
- Valid for orders of up to 3 unit
- Appointment coordination in advance
- Accuracy: 0.05%
- Frequency range: 50 Hz - 100 kHz
- Measuring speed: 13ms
- DCR: 0.00001 Ω - 99.9999 MΩ
- Resolution: 6 digits
- Display: Colour TFT 4.3"
- Interfaces: USB, RS232, handler, optional: GPIB
- Extra: ST®Meter 4.0 software, incl. accessories
 (1)_400x400.jpg?ts=1657702146 "Winding Goods Test System STW")
- Fully automatic Relay matrix STM-8-4
- User-friendly ST®EOL software
- Modular 19″ industrial cabinet
- Industrial PC with WIN 10 or higher
- Touch monitor, scanner and label printer
- Safety standard IEC/EN60947-5-1
- CE compliant according to EN 50191
- Devices: 36 & 400
- 4-pin (sense/source)
- PE connector: PES4
- Lamella plug: 4mm
- Operating current: 32 A AC
- 10.000 V Megohmmeter
- Insulation resistance 10 kΩ - 10 TΩ
- Digital & bar-graph reading
- Auto-tests: Absorption Ratio, Polarization
index, Capacitance, Leakage current,
AC/DC voltmeter - Switchable filter to remove external-noise
- Step voltage test
- Built-in printer (option)
- 4000 readings memory
- Isolated USB data port
- Bluetooth interface
- Software for data management
- Rechargeable battery
- 100 A Low-Resistance-Meter
- Direct reading up to 4 ½ digits
- Resolution: 0.1 µOhm
- Heavy duty equipment
- Overheating protection
- Internal memory for 200 readings
- USB Port
- Protection IP54