Certified quality management system
Measurement Technology
Measurement engineering is a major division of Sourcetronic. Your measurement engineering specialist, specialized on highly diverse measurements, such as resistor measurements, LCR, high voltage, isolation resistors, security tests but as well multimeters, oscilloscopes and software.
- Devices: ST9201S
- Voltage: 10,000 VAC
- Cross-section: 4 mm²
- Length: 1.50 m
- 8 x HV cable red with:
- HV connector white
- HV terminal insulated red
- 1 x HV cable black with:
- HV plug black
- HV clamp insulated black
- Measurement display range: 1µΩ - 2MΩ
- Basic Accuracy: 0.05%
- 4.3" color-touch-display
- Resolution: 10µΩ - 10Ω
- Interface: Handler, RS2323C, USB
- Temperature measurement
- Measurement range: 100kΩ - 10TΩ
- Voltage range: 1V - 500V
- 4.3" color-touch-display
- Comparator function: PASS (3 bins) and FAIL (1 bin)
- Interface: Handler, RS232C and USB
- 5000 VAC high voltage test
- 1000 VDC insulation resistance test
- 25 A protective earth test
- Short Circuit and Open Loop test
- 230V single-phase function test
- 5.7" TFT-Industrial-Touch-Screen
- Large variety of interfaces
- DataView software
- Compatible with wired LCR Meter
- 4-Terminal fixture
- BNC connectors
- Gilded contacts
- Max peak voltage 100V DC
- Including cable-set for hipot tester 28 series:
UH28C, UH28, UH28CS, A, M, P - Ergonomically design
- Push-start-buttons: 2
- Normed distance between buttons
- Connecting cable: 2.5 m
- 4-wire-technique
- Start-Stop-function
- Result indication LED
- Cable length: 2m
- 8000 VDC high voltage test
- 40 A protective earth test
- 1000 VDC insulation test
- 5.7" TFT-Industrial-Touch-Screen
- Large variety of interfaces
- Norms: DIN ISO EN 60204
- DataView software
- Devices: 400 series
- Mounted on test trolley
- Total hight of lamps 1850mm
- Standard: EN 50191, VDE0104
- Lights: Red/Green
- Function: operation, switch on, ready
- Cable length: 3m
- HV Test: 100kV AC
- Test current: 0.5mA - 100mA
- 10k VA power / potential free
- With oil transformator
- Burning function and ramp
- Digital voltage control
- RS232, digital I/O (SPS), CAN
- Software, DLL, LabView, Active-X (option)
- Work place according to EN 50191
- Low inductance impulse test: Down to 10µH
- Four kinds of waveform comparison methods
- 200MS/s sampling rate
- Channel: 8
- Three-Phase version available
- Voltage up to 5000 V
- Analysis: face, differential area, corona, phase difference
- remote control: Handler, RS232, LAN
- good/bad Analysis
- High voltage test up to 5000V AC / 6000V DC
- Safety current limited up to 3mA
- Insulation resistance test up to 10 GOhm
- Rapid discharge of DUT and ARC Detection
- Interfaces: Handler (5V, 12 V, 24 V),
RS232, Remote I/O, SCAN (optional), USB (ST9201S),
GPIB (optional) - First class readability by VFD display
- Inclusive HV-accessories