Certified quality management system
Measurement Technology
Measurement engineering is a major division of Sourcetronic. Your measurement engineering specialist, specialized on highly diverse measurements, such as resistor measurements, LCR, high voltage, isolation resistors, security tests but as well multimeters, oscilloscopes and software.
- Devices: 400 series
- LED - warning lamp
- Standard: EN 50191, VDE0104
- Lights: Red/Green
- Function: operation, switch on, ready
- Cable length: 2m
- Contact configuration: 2 changeover contacts
- Monostable direct current relay
- Excitation coil: 24 VDC / 0.07 A
- Switching capacity max. 5000 VA (resistive load)
- Switching current max. 10 AAC
- Continuous current max. 25 AAC
- Temperature range -25 °C to +40 °C
- Switching frequency max. 1 / sec
- Mechanical switching cycles 5 * 10^6
- Low inductance impulse test: Down to 10µH
- Four kinds of waveform comparison methods
- 200MS/s sampling rate
- Channel: 4
- Three-Phase version available
- Voltage up to 5000 V
- Analysis: face, differential area, corona, phase difference
- 3-phase
- remote control: Handler, RS232, LAN
- good/bad Analysis
- Triangle design
- With flash arrow
- Material: plactic
- Size: 200mm x 200mm
- Colour: yellow/black
- DIN 40008
- HV-Cable single-pole, yellow
- 2 x HV-Plug HVP06N
- 7 kV AC / 10 kV DC, max. 10 A
- Wide range of devices supported
- Cleaning and adjustment
- Repair service
- 5000 VAC high voltage test
- 32 A protective earth test
- 5.7" TFT-Industrial-Touch-Screen
- Large variety of interfaces
- Norms: DIN ISO EN 60204
- DataView software
- Including cable-set for hipot tester:
36 series (UH36/UX36) - Ergonomically design
- Push-start-buttons: 2
- Normed distance between buttons
- Connecting cable: 2.5 m
- Optical signals
- Inklusvie kompletten Anschluss-Satz für:
400er Sicherheitsprüfgeräte ST400 - Start-Taster, PE-Funktionalität
- Einbindung Sicherheitskreis
- Zwei-Hand-Bedienung mit HV-Probe
- Optische Status-Anzeige
- Ergonomisches Design
- Anschlusskabel: 3 m
- Emergency stop with 5 m cable
- Circuit of the tester could be opened
- Not possible to switch on high-voltage again
- Rectangle design
- "Danger High Voltage"
- Material: plactic
- Size: 74mm x 210mm
- Colour: yellow/black
- EN50191 / DIN 40008
- BNC cable contact
- High quality BNC connectors
- LCR meter / DC bias source
- Approximately 50cm long