Certified quality management system
Measurement Technology
Measurement engineering is a major division of Sourcetronic. Your measurement engineering specialist, specialized on highly diverse measurements, such as resistor measurements, LCR, high voltage, isolation resistors, security tests but as well multimeters, oscilloscopes and software.
- Low inductance impulse test: Down to 10µH
- Four kinds of waveform comparison methods
- 200MS/s sampling rate
- Channel: 4
- Three-Phase version available
- Voltage up to 5000 V
- Analysis: face, differential area, corona, phase difference
- 3-phase
- remote control: Handler, RS232, LAN
- good/bad Analysis
- Triangle design
- With flash arrow
- Material: plactic
- Size: 200mm x 200mm
- Colour: yellow/black
- DIN 40008
- Measurement range: 10kΩ to 50TΩ
- Voltage:10V - 500V
- 320×240 dot-matrix LCD
- Comparator function: PASS (3 bins) and FAIL (1 bin)
- Interface: Handler, RS232C, USB (GPIB optional)
- Dual outputs
- HV-Cable single-pole, yellow
- 2 x HV-Plug HVP06N
- 7 kV AC / 10 kV DC, max. 10 A
- Wide range of devices supported
- Cleaning and adjustment
- Repair service
- 5000 VAC high voltage test
- 32 A protective earth test
- 5.7" TFT-Industrial-Touch-Screen
- Large variety of interfaces
- Norms: DIN ISO EN 60204
- DataView software
- Including cable-set for hipot tester:
36 series (UH36/UX36) - Ergonomically design
- Push-start-buttons: 2
- Normed distance between buttons
- Connecting cable: 2.5 m
- Optical signals
- Inklusvie kompletten Anschluss-Satz für:
400er Sicherheitsprüfgeräte ST400 - Start-Taster, PE-Funktionalität
- Einbindung Sicherheitskreis
- Zwei-Hand-Bedienung mit HV-Probe
- Optische Status-Anzeige
- Ergonomisches Design
- Anschlusskabel: 3 m
- Emergency stop with 5 m cable
- Circuit of the tester could be opened
- Not possible to switch on high-voltage again
- Max current: 32A AC
- Length: 5 m
- PE test lead, 2-pole
- Source path with 6mm plug for insertion to the device
- Sense path with BNC-plug for insertion to the device
- Rectangle design
- "Danger High Voltage"
- Material: plactic
- Size: 74mm x 210mm
- Colour: yellow/black
- EN50191 / DIN 40008
- BNC cable contact
- High quality BNC connectors
- LCR meter / DC bias source
- Approximately 50cm long