Certified quality management system
Measurement Technology
Measurement engineering is a major division of Sourcetronic. Your measurement engineering specialist, specialized on highly diverse measurements, such as resistor measurements, LCR, high voltage, isolation resistors, security tests but as well multimeters, oscilloscopes and software.
- Max current: 32A AC
- Length: 2 m
- PE test lead, 2-pole
- Source path with 6mm plug for insertion to the device
- Sense path with BNC-plug for insertion to the device
- Electrical Safety Tester Calibration (EST)
- HV test, earth bond test, ISO test
- Calibration of parameters: 3
- Calibration certificate in accordance to ISO 17025
- Repair service on request
- Cable length: 1.5 m
- PVC design housing
- Transparent viewing hood
- Damped gas spring
- Safety switch
- Standard-compliant coating
- CE compliant according to EN 50191
- Devices: 400 series
- LED - warning lamp
- Standard: EN 50191, VDE0104
- Lights: Red/Green
- Function: operation, switch on, ready
- Cable length: 2m
- Contact configuration: 2 changeover contacts
- Monostable direct current relay
- Excitation coil: 24 VDC / 0.07 A
- Switching capacity max. 5000 VA (resistive load)
- Switching current max. 10 AAC
- Continuous current max. 25 AAC
- Temperature range -25 °C to +40 °C
- Switching frequency max. 1 / sec
- Mechanical switching cycles 5 * 10^6
- Low inductance impulse test: Down to 10µH
- Four kinds of waveform comparison methods
- 200MS/s sampling rate
- Channel: 4
- Three-Phase version available
- Voltage up to 5000 V
- Analysis: face, differential area, corona, phase difference
- 3-phase
- remote control: Handler, RS232, LAN
- good/bad Analysis
- Triangle design
- With flash arrow
- Material: plactic
- Size: 200mm x 200mm
- Colour: yellow/black
- DIN 40008
- Measurement range: 10kΩ to 50TΩ
- Voltage:10V - 500V
- 320×240 dot-matrix LCD
- Comparator function: PASS (3 bins) and FAIL (1 bin)
- Interface: Handler, RS232C, USB (GPIB optional)
- Dual outputs
- HV-Cable single-pole, yellow
- 2 x HV-Plug HVP06N
- 7 kV AC / 10 kV DC, max. 10 A
- Wide range of devices supported
- Cleaning and adjustment
- Repair service
- 5000 VAC high voltage test
- 32 A protective earth test
- 5.7" TFT-Industrial-Touch-Screen
- Large variety of interfaces
- Norms: DIN ISO EN 60204
- DataView software
- Including cable-set for hipot tester:
36 series (UH36/UX36) - Ergonomically design
- Push-start-buttons: 2
- Normed distance between buttons
- Connecting cable: 2.5 m
- Optical signals